Wolf · Weston, MA
Range Hood Repair
Wall, island, insert and pro-style hoods with remote or in-line blowers, which is what the high-ceilinged kitchens here tend to run. Motor and capacitor faults, speed controls, lighting, filter hardware and duct diagnosis.
In the caller's words
What gets described
- Hood humming without clearing smoke off the range
- Baffle filters loose in their track
- Lamps cutting out once the hood warms up
- Remote or wall control no longer changing speed
On the visit
What gets measured
- Blower amp draw at every speed against the rating plate
- Baffle and mesh loading, and the state of the grease trough
- Damper flap travel at the hood and again at the roof or wall cap
- Duct run for crushed sections, long flexible lengths and reductions
- Capacitor condition on a remote or in-line blower, which is where these usually go
Flat $95 service call, credited in full against the repair. Nothing is ordered before you have agreed a figure.
What repairs run to
A ledger, not a quote
Most work lands inside one of these bands once the diagnosis is done. What you are given on the day is a fixed figure for your appliance, and nothing is started until you have agreed it.
- Igniter or spark module replacement
- $270 $680
- Burner valve or orifice service
- $260 $1,040
- Oven thermostat or sensor calibration
- $140 $710
- Convection fan or motor
- $330 $880
- Control board or touch panel
- $510 $1,600
- Door hinge, glass or seal
- $200 $980
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.
Also on the van
Next step
Say what it is doing
The model number and one clear sentence about the fault is enough to load the van properly. Flat $95 service call, credited in full against the repair.