Skip to content
Wolf Repair Weston, MA

Wolf · Weston, MA

Cooktop Repair

Gas, induction and electric Wolf cooktops in island counters and back runs. Burner caps and igniters, induction coils and power boards, touch and knob controls, and the wiring beneath a stone counter.

Close three-quarter view of a gas cooktop and control panel with one burner cap lifted off, the oven door open below and a wrench on the counter

In the caller's words

What gets described

  1. Flame lifting off the burner cap instead of sitting on it
  2. Induction element buzzing at medium power
  3. Every position sparking at once when one knob is turned
  4. A zone that works only at maximum

On the visit

What gets measured

  • Burner port pattern and flame colour at full and at low
  • Spark electrode gap and the condition of its porcelain
  • Induction inverter temperature and cooling airflow under sustained load
  • Touch or knob control response and relay behaviour at every zone
  • Wiring and connector condition in the cavity beneath a stone counter

Flat $95 service call, credited in full against the repair. Nothing is ordered before you have agreed a figure.

What repairs run to

A ledger, not a quote

Most work lands inside one of these bands once the diagnosis is done. What you are given on the day is a fixed figure for your appliance, and nothing is started until you have agreed it.

Igniter or spark module replacement
$270 $680
Burner valve or orifice service
$260 $1,040
Oven thermostat or sensor calibration
$140 $710
Convection fan or motor
$330 $880
Control board or touch panel
$510 $1,600
Door hinge, glass or seal
$200 $980

Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.

Also on the van

Afterwards

After a cooktop repair call

4.9out of 5, from 977 reviews

  • One zone worked only at maximum. The power board had a failed output stage. He confirmed it with a meter instead of guessing, ordered the board and fitted it the following week.

    Quentin L. — Hastings

  • Every position sparked at once when one knob turned. Water from a boilover had bridged the switches under the glass. Dried out, one switch replaced.

    Isolde V. — Silver Hill

  • An induction element buzzed loudly at medium power. The coil mounting had loosened and was resonating against the frame. He shimmed and retorqued it, and it is barely audible now.

    Dashiell R. — Kendal Green

Next step

Say what it is doing

The model number and one clear sentence about the fault is enough to load the van properly. Flat $95 service call, credited in full against the repair.

A stainless range in white cabinets with the oven door lowered flat, showing the door glass and the cooktop grates above